Changelog 2.54
+++++++++++++++++++++++++++++
* Payload and Tier Info
+++++++++++++++++++++++++++++
Changelog from Fort. 2.53
* Card support HD + HD03 and HD03A> permissions are displayed under card info
* New Point menu Cam Reset
* Auto - Cam Reset (after changing the module menu, a cam reset, the previous drawing / plugging is therefore no longer necessary)
* Manual Emm (may be useful to Pairing / Marry at best, prevent or delay ...)
Menu item under card information> EMM blocker> EMM manual off / on
It can be distinguished to be stored EMM.
unique, global or shared
for of prolongation enough unique
setting:
Blockemm-u Off
Blockemm-s ON
Blockemm-g ON
Bylen Off
manual EMM ON
So the last 5 unique EMM will be saved
In some tests, so could the card without getting Pairing be extended by a few weeks!
-----------------------------------------------
statement Block Function: Important: Limited effectiveness may no longer / or
* Automatic block EMM for V13, V14 under Mode On / off
Menu> Settings> Mode> auto emm len for v13 / v14 on / off
(Proven block EMM containing lengths for V13 and V14 1-29,31-35,37-47,50,52-53,55- 1-38,40,42-44,65-124,126-127,131,139-255 in this option )
* Message if card paired
This software constitutes an expanded display function under Card Info CAS-ID. For example, whether the card is used to V13, V14 already paired,
or whether Tier's are expired ...
* EMM block function for various cards (especially for s*y V13, V14), length can be determined by the user in the menu card information.
(Blocker is preventing the pairing (To prevent marry the s*y card with rental receiver or CI + module of the Provider, or at least delay) a trial.
Can only be callable if there is a smart card in the module.
Menu> Card Information> respective Caid of the inserted card ( nds (9C4) etc,,,> Select Display CAS-ID, serial number, Entitlement, EMM Blocker> EMM blocker select> setting
Blockemm-u (blocked only unique EMM)
Blockemm-s (blocked only shared EMM)
Blockemm-g (blocked only global EMM)
Blockemm-Bylen (This EMM can be all listed here, blocked with a specific length.)
give them EMM length (Here is the manual input)